5-16
Audio/Satellite radio operation (type B audio)
selected as the source.
Turn the TUNE/TRACK/CH dial to select
the satellite radio channel.
Band selection
XM button
Push the XM button when the radio is off
to turn on the radio.
Push the XM button when the radio is on
to select XM1, XM2 or XM3 reception
mode.
Channel and category selec-
tion
Channel selection
CH dial
Turn the CH dial clockwise to select the
next channel and turn the CH
counterclockwise to select the previous
channel.
Category selection
PTY/CAT button
To activate the category search mode,
press the PTY/CAT button. To deactivate
the category search mode, press the
PTY/CAT button again.
When in the category search mode, press
the following button to change the cate-
gory up or down.
Category up by one
step
Category down by
one step
When a category is selected, turning the
TUNE/TRACK/CH dial selects channels
only within the selected category.
The control function returns to the normal
mode after approximately 8 seconds.
Channel scan
SCAN button
dial
Press the SCAN button to change the
radio to the SCAN mode. In this mode,
under the selected category, the radio
scans through the channel until a station
is found. The radio will stop at the station
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned.
Press the SCAN button again to cancel
the SCAN mode and to stop on any
displayed channel.
Channel preset
How to preset channels
1. Press the XM button to select the
preferred reception mode.
2. Select the desired channel.
3. Press and hold one of the preset
buttons (from
to
than 1.5 seconds to store the channel. If
the button is pressed and held for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
. Up to six channels for each recep-
tion mode may be preset.
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all channels stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
) for more