Group Bypass; Unbypassing; Adding And Changing User Codes - Interlogix Caddx User Manual

GROUP BYPASS

Pressing [BYPASS]-[0]-[BYPASS] will bypass all zones that are designated as group
bypass zones. Press [BYPASS] again to exit group bypassing.

UNBYPASSING

To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. The corresponding light for that zone will go off when unbypassed.
NOTE: All zones will automatically be unbypassed each time the system is
disarmed.

ADDING AND CHANGING USER CODES

Your system must be Disarmed to change user codes.
Press [7]-[5]-["Master Arm/Disarm" Code].
1.
NOTE: For partitioned systems, someone changing the code of another person
must have access to all or more partitions than the user being changed.
The ready light will flash.
2.
Enter the "user number". (Depending on the control panel in your system, this will
3.
be either a 2-digit or 3-digit number. Remember to enter leading zeros such as
[0]-[3] for user 3, or [0]-[5]-[2] for user 52).
The zone lights will illuminate specifying the first digit of the "user code". (Lights
4.
1-8 on = code is blank, lights 1-8 off = "0", lights 1 and 8 = "9").
To DELETE a user code, enter [7]-[7]-[7]-[7] for a 4-digit code, or [7]-[7]-[7]-
5.
[7]-[7]-[7] for a 6-digit code.
The ready light will flash indicating you are back at Step 2 above. If the code is
6.
rejected, the sounder will beep 3 times.
Return to step 3 if another "user code" is to be programmed.
7.
Press [#] while the ready light is flashing to exit the User Code Programming
8.
Mode.
LED Keypad