Appendix C: Messages - Garmin eMap Owner's Manual

The eMap uses an on-screen pop-up message system
to alert you to unit operating characteristics. Press the
ENTER key to acknowledge and return to the page you
were viewing.
Approaching Turn - You are less than one minute
away from a turn in your route.
Arriving at Destination - You have reached your
destination.
Base Map Failed - The unit' s base map has failed.
Return your unit to GARMIN for service.
Batteries Low - The batteries in your unit are low
and no longer capable of supporting unit operation.
Install new batteries.
Database Error - There is an error in the unit' s
database. Service is required.
GPS Turned Off (for use indoors) - The eMap' s
GPS receiver has been turned off to conserve battery
power and speed Map Page display redrawing.
Lost Satellite Reception - The unit has lost
satellite signals. Try moving to another location with a
clearer view of the sky.
No Differential GPS Position - The beacon receiver
is not communicating with the unit. Refer to the
'Interface' setup page of the unit to view messages in the
'Status' field.
None Found - There is no such address, intersection,
point of interest, or city in the map information database.
Check spelling or number entry and try again.
RAM Failed - The eMap has detected a failure in its
internal memory. If the message persists, service is
required.
ROM Failed - The permanent memory has failed
and the unit is not operable. Service is required.
Route Memory Full - No additional waypoints can
be added.
Route Truncated - A complete uploaded route will
not fit into memory. Modify the route to reduce size.
Appendix C
Messages
31