Battery Installation; Map Cartidge Installation - Garmin eMap Owner's Manual

Installing the Batteries
The eMap operates on two AA batteries, which are
installed by removing the cover on the back of the unit.
These batteries will provide more than 10 hours of
continuous use. Rechargeable NiCad or lithium batteries
may be also used. Stored data will not be lost when the
batteries are removed.
To install the batteries:
1. Open the battery compartment on the back of the
unit by pressing the two arrows on the cover. Slide
it back and then lift up to remove.
2. Install the batteries according to the polarity
markings in the battery compartment.
3. Press the cover onto the compartment then slide
forward until it clicks back in place.
Installing GARMIN Map Data Cartridges
GARMIN map data cartridges allow your unit to
display detailed mapping data. Data can be downloaded
from a GARMIN MapSource
data for a specific area, USA, World Map, etc.) using a PC
and interface cable. MetroGuide
available for all major US cities. Refer to Appendix A for
MapSource and MetroGuide ordering information.
To install map data cartridges:
1. Open the battery compartment cover on the back of
the unit by pressing the arrows, sliding back, then
lifting up.
2. Remove the batteries to expose the cartridge slot at
the back of the compartment.
3. Insert the cartridge in the slot with the label facing
you. Be certain the connector end is inserted into
the slot and not the end with the extractor handle.
Press the cartridge completely in place until the
handle is in place and is flush with the side of the
compartment.
4. To remove the cartridge, use a fingernail to pull out
the extractor handle and then slide the cartridge
free of the slot.
5. Reinstall the batteries and close the cover.
CD-ROM ( a collection of
®
® cartridges are also
Reference
Battery
Installation
Remove battery compartment
cover, observe polarity
markings, install batteries
and reinstall cover.
Map Data
Cartridge
Installation
Install the map data cartridge
in the indexed slot at the back
of the battery compartment.
Push in carefully, until it is
completely in place.
Pull out the extractor handle
to remove the map data
cartridge from the eMap
battery compartment.
1