Table of Contents
Advertisement
780 SERIES
C. When the overtemp has been activated, the white decimal point after
the last digit will flash on and off every second as an indicator for
being in the overtemp mode.
Note: Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps above.
9.2
Activate Jets Pumps
The JETS 1 button activates the functions of the main
2-speed jets pump. The first press activates pump 1 in low speed,
the second press activates high speed, and the third press shuts
the pump off. For 2-pump models, the JETS 2 button controls jets pump
2 which only operates in high speed. When manually activated, both
pumps automatically turn off in 20 minutes.
9.3
Selecting Desired Massage Action
Your Sundance spa is equipped to allow you to customize
the massage action you desire. Each model incorporates a
massage selector that allows you to customize the
massage and performance by diverting water between
various jet systems. Simply turn massage selector to position A (Combo),
B, or C to divert water pressure to various jet groups.
Note: The massage selector is designed to operate in positions A
(Combo), B, and C for optimum performance. It is considered normal for
sound levels within the valve to vary between positions due to the large
amounts of water flowing through it. For optimum filtration benefits, leave
the valve in position A when spa is covered. Select position B or C for
maximum jet performance during spa use.
9.4
Air Controls
Certain jet systems have their own air control. Each control
introduces air into the water lines that supply specific jet
groups. Simply rotate any air control knob clockwise to open, or
counterclockwise to close.
Note: To minimize heat loss, close all air controls when spa is not in
use. Certain jets may not draw air while the jets pump is running in low
speed; this is considered normal.
Page 26
2
1
B
C
A
Hide quick links:
Advertisement
Table of Contents
