Viewing Bus Devices - Honeywell XI581AH User Manual

ALPHABETIC REFERENCE

Viewing Bus Devices

Access Level
EN2B-0126 (74-3554-8)
Use the up/down arrow keys to move
to and highlight Yes. Press Enter (↵)
to select 'Yes' and to reset the
totalizer.
RESULT: The controller resets the
NOTE: To avoid resetting the
5. Press Cancel (C) or 'Back' to return to the totalizer data point list. When you are
finished, repeatedly press Cancel (C) to return to the Main Menu.
Purpose To display a list of devices currently active on the system bus. The list can include
devices that do not have buswide access capability so a remote log-in may not be
possible to all the listed devices.
All users can perform this task. The display is available only while in local controller
mode.
Procedure 1. From the Main Menu, use the arrow keys to move to and highlight System data.
Press Enter (↵) to complete the selection.
RESULT: The display window show some controller data and the Buswide
System Data
2. Use the arrow keys to move to and highlight Buswide Access and press Enter
(↵) to complete the selection.
RESULT: The display window lists the buswide access options you can choose.
Buswide Access
CONTROLLER_01
Remote Login
Show All DevicesAlarm Standby Off
XI581/2 BUSWIDE OPERATOR INTERFACE
Reset the Totalizer
totalizer and the display
window returns to the list
of totalizer points. Notice
that the accumulated
number for the reset point
is zero.
totalizer, use the arrow keys
to move to and highlight NO
and press Enter (↵).
Access option.
System Info
HW-Interface Config.
Flash EPROM
Buswide Access
Alarm Standby On
Alarm Standby Flag
96
Define Service Interval
Use the arrow keys to move to and
highlight the Service interval field.
Press Enter (↵).
RESULT: The entry in the Service
interval field starts
blinking and the high-
lighting disappears.
Press the plus or minus key to incre-
ment or decrement the Service Inter-
val digit from 0 to 9. Use the right or
left arrow key to move to the tens,
hundreds, thousands, etc., digit.
Press Enter (↵).
RESULT: The entry in the Service
interval field stops
blinking but is highlighted.