Saeco Classic Service Manual page 90

5. SERVICE PROGRAMME
Function
TOTAL WATER....S2
(ml) Number
WATER DESCALING
S2
(ml)
HOT WATER
FLOW (l/h) 20
HEISSWASSER---
PUMPENREG 63000
WATER RESERVE
NUMBER
No. of PULSES
1000
From Version: 2003
WATER RES. STOP
No. of PULSES
NUMBER
From Version: 2003
TURBO FACTOR
MACHINE STATUS
100
--DATE OF MANUF---
DAY
--DATE OF MANUF---
MONTH
--DATE OF MANUF---
YEAR
--SERVICE DATE--
DAY
--SERVICE DATE--
MONTH
--SERVICE DATE--
YEAR
Exit: Switch the machine off at the main switch.
Page 20/24
Setting range Increment
6 – 34 1/h
58,000 - 65,500
1-2500
1-2500
10 - 250
0 - 255
--------------------- ------------------
--------------------- ------------------
--------------------- ------------------
0 - 31
0 - 12
1996 - 2050
REV.4 SEPT.2003
Comments
Pump system 2
Total water flow volume (in ml) /
not resettable
Pump system 2:
Total water flow (in ml) since last
descaling.
Reset: See S1
+/- 2 1/h The pump delivery rate for hot
water can be expressed in litres per
hour.
+/- 1 The pump delivery rate is adjusted
in relation to the HOT WATER
FLOW setting by means of a phase
controlled modulator. Pump
tolerances can thus also be
adjusted. An equivalent value is
saved under HOT WATER PUMP
ADJUSTMENT.
Counts the pulses programmed
under water reserve stop from
when the reed switch switches.
The indicator signalling the need
to fill the water tank then appears.
Number of residual pulses from
when the reed switch switches to
when the water low indicator
appears. (can be changed)
Conversion factor for pressure-
resistant flow meter.
(Setting value for Roy. Profess.:
100
(Setting value for Roy. Coffeebar:
77
Operating status
This date indicates when the
machine was manufactured. This
-----
date cannot be changed.
-----
-----
+/- 1 The service date indicates the date
of the machine's last service. This
date can be changed and must be
+/- 1
updated at each service.
+/- 1
ROYAL
Saeco International Group