Saeco Classic Service Manual page 134

9. DISASSEMBLY
c) Lift the heater out of the machine and exchange parts as necessary. In
order to exchange the thermostat or the sensor, remove screw (1) and the
fixing clamb.
d) Attention: The metal cylinder (Fig. 24/1) of the thermal sensor (KTY)
must be transferred from the old sensor to the new sensor when the sensor
is replaced!.
e) When re-assembling ensure that sufficient heat conductive paste is used
(Fig. 24/2).
Seite 14/20
1
Fig. 23
2
Fig. 24
REV.4 SEPT.2003
1
Saeco International Group
ROYAL