Quitting The Surveying Function - Magellan ProMark3 RTK Getting Started Manual

Make sure the rover
antenna has the best pos-
sible view of the sky at all
times during the survey.
This should result in #Sats
continuously greater than
4 and PDOP continuously
less than 4.
The Obs. Range field is
irrelevant to the kine-
matic mode and for this
reason is left blank.
0001...
Log
Rover
Pause
Log
0015...
Bold lines indicate the tra-
jectories surveyed.
54
9. Tap the on-screen Log button and then walk along the tra-
jectory. The screen then looks like this:
As you are progressing along the trajectory, the content of
the Site ID field will be incremented by 1 at the recording
interval rate (increment: 0 to 9, then A to Z, then 0..
again, etc.).
Use the buttons at the bottom of the screen to do the fol-
lowing:
• Pause: Tap this button when you arrive at the end of
the trajectory. The button is then renamed "Log". Tap
the Log button when you are at the start point of a new
trajectory you want to survey. Be careful not to mask
the antenna between the two trajectories.
• Done: Will end the kinematic survey by closing the
data file and taking you back to the last displayed nav-
igation screen. (After selecting Done, the receiver is
idle but still in the Surveying function.)

Quitting the Surveying Function

Press the MENU key and tap Exit. This takes you back to the
ProMark3 workspace screen.