Downloading Rtk Data - Magellan ProMark3 RTK Getting Started Manual

Files resulting from the
downloading of an observa-
tion file are named as fol-
lows:
X<Downloadedfilename>
where prefix X = "E" for
Ephemeris Data, "B" for
Position Data, "D" for GPS
Raw Data and "W" for
SBAS Data.
64
- Press the F5 key. A Copying file dialog appears during
data transfer.
After the transfer is complete, notice in the right side
of the Download window that each downloaded file has
been split into different files named with a prefix as
explained opposite.
- Close the Download window.
5. On ProMark3, quit the Surveying function, turn off the
receiver and remove the cable between the PC and
ProMark3.
6. Repeat the previous 5 steps for each of the ProMark3
units involved in the project to download their respective
files to the same project folder on your office computer.

Downloading RTK Data

1. Resume steps 1 to 3 described in Downloading Raw Data
on page 62.
2. On the PC:
- Run GNSS Solutions and open or create the project in
which to download your RTK results.
- In GNSS Solutions, select Tools>Preferences and make
sure Show RTK functions is enabled, otherwise check it
and then click OK.
- Select Project>Download Positions from External Device.
- Select ProMark3 Surveying and click OK. This launches
the Download Utility on the PC. The left side of the
Download window then lists the files present in the
ProMark3 RTK.
- Select the O-files you want to download
- Press the F5 key to start the file transfer.
- When the transfer is complete, close the Download
window. The RTK results are now visible in the project
open in GNSS Solutions.