One-Arm Drive - Invacare XLT Power U-front Service Manual

1.
2.
B
Tools: 4 mm Allen Key
10 mm fixed spanner
B
Tools: 5 mm Allen Key
4 mm Allen Key
32

ONE-ARM DRIVE

A
C
D
ANTI-TIP DEVICE FOR ONE-ARM DRIVE
A
The quick release one-arm drive allows the user to
propel the wheelchair with one hand. Two hand rims
are mounted on the same rear wheel. The one-arm
drive wheel can be mounted on either the left or the
right side.
1a. Detaching the wheel
Pull the knob (A) and remove the wheel from the
hub.
1b. Attaching the wheel
Pull the knob (A) and push the wheel back onto
the hub.
It is very important that you check that the
locking pin has actually locked the wheel into
position when the knob has been released.
Take hold of the wheels and try to detach
them. This should NOT be possible.
The hand rims can be positioned either level with each
other (internal position) or with the inner, smaller
hand rim protruding slightly (external position).
2. Changing the position of the hand rims
Unscrew the three screws (B), remove the hand
rim and turn it over. Put it back into position and
firmly retighten the three screws.
Take care when removing the telescopic trans-
mission shaft. Point it away from the body when
releasing the powerful spring.
Please note! The transmission shaft (C) is an integral
part of the wheelchair and the user will be unable to
propel the wheelchair without it.
Take care not to trap your fingers between
the spokes and the three bars of the outer
handrim (D).
For information about usage and safety, read the page
about anti-tip devices in this manual.
Mounting
1. Attach the adapter plate to the anti-tip device with
the screws (A) using a 5 mm Allen key.
2. Attach the anti-tip device with adapter plate to
the rear wheel attachment with the screws and
washers (B) using a 4 mm Allen Key.
INVACARE XLT Service Manual
®