Invacare XLT Power U-front Service Manual page 15

1.
A
Tools: 4 mm Allen key
10 mm fixed spanner
2.
Tools: 24 mm fixed spanner
3.
A
Tools: 4 mm Allen key
10 mm fixed spanner
INVACARE ® XLT Service Manual
Angle adjustment, fine adjustments
When you have decided the direction in which you
want to tilt the backrest, it is time to make the fine
adjustments, i.e. adjusting the backrest to suit your
body. Proceed as follows:
B
1. Loosen the four nuts (B) on the inside of the
backrest tubes with 1- 2 turns with a 10 mm fixed
spanner. Hold screws (A) firmly in place with a
4 mm Allen key.
2. Then, using a 24 mm fixed spanner, turn the plates
– a little at a time, first on one side of the chair,
then on the other side. By this alternating proce-
dure, you can adjust the tilt of the backrest.
Note! You must alternate between the two plates
whenever you turn them, otherwise, the backrest
could become twisted, and its ergonomic advantages
will be lost.
3. Once you have found the right position, retight-
en the nuts on the inside. Hold the screws (A)
firmly in place with the Allen key.
The tip risk increases the further back the
backrest is tilted. We recommend the use of
B
anti-tip devices.
15