One Arm Drive By Lever - Invacare Action 3 NG User Manual

Invacare® Action 3 NG
Two positions of the small handrim are possible to
facilitate the propulsion: internal position or external
position. Make sure that 3 screws B are locked into
position.
CAUTION!
Risk of injury
– Its recommended that the change of control
side and position of the small handrim must be
carried out by an authorized provider.
Disengage the telescopic rear wheel shaft
To fold the wheelchair it is necessary to disengage the
telescopic rear wheel shaft C .
1. Disengage the telescopic shaft C by sliding one part
inside the other.
2. To facilitate this operation move the small handrim
forwards to backwards.
3. Reverse the procedure to reinstall.
CAUTION!
Risk of accident
– The telescopic rear wheel shaft C is an integral
part of the wheelchair and the user will be
unable to propel the wheelchair without it.
34

4.4 One arm drive by lever

The One arm drive by lever control system (left or right
hand) allows the user with low muscular tone to propel
the wheelchair with a single arm. The user grips the drive
motion lever which propels the wheelchair frontwards or
backwards (reversing gear lever A, central position is the
neutral gear) thanks to an in and out movement; steering is
performed by simply turning the drive motion lever to the
LH/RH side and braking by pulling the drive motion lever
backwards. The OADL system is always delivered in passive
rear wheel position for a better stability.
The drive motion lever can be removed to facilitate
transfer or to move next to a table ; loosen the
handle lever B and pull up the drive motion lever.
Reverse the procedure to reinstall.
The manual brake is always located opposite to the
control system.
CAUTION!
Risk of pinching or crushing
There may be a very small gap between the rear
wheel and the transmissions links with the risk
that you could trap your fingers.
– Keep your fingers away from movable parts
when using the OADL system, always keep your
hand on the hand lever.
1608467-E