Armrests/Mudguards - Invacare XLT Power U-front Service Manual

1.
Tools: 5 mm Allen key.
2.
Tools: 5 mm Allen key.
3-4.
D
C
Tools: 3 mm Allen key
5 mm Allen key
5.
Tools: 5 mm Allen key.
INVACARE ® XLT Service Manual
ARMRESTS/MUDGUARD
A
B
F
Adjusting the height of the armrests
1. Flip up armrest
If your chair is equipped with armrests that can be
raised or lowered, this is achieved by loosening the
screw (A), moving the armrest into the required
position and retightening the screw.
When adjusting the height, do not place
your fingers between armrest pad and side
plate as they may get trapped.
2. Detachable armrest
If your chair is equipped with armrests that can
be raised or lowered, this is achieved by pulling
up the armrest and loosening the screw (B) under
the armrest. Move the screw up or down to the
desired position and retighten the screw. Lower
the armrest again.
When adjusting the height do not place your
fingers between seat tube and side plate as they
may get trapped.
3. Mudguard
Adjust the height of the mudguard by pulling up
the mudguard and loosening the screw (C). Move
the screw up or down to the desired position and
retighten the screw. Insert the mudguard again in
it's attachment.
When adjusting the height do not place your
fingers between seat tube and side plate as they
may get trapped.
4. To adjust the depth of the mudguard, unscrew
screws (D) using an Allen key. Move the mudguard
into the required position and fasten the screws
again.
5. Adjusting the play
The armrests and mudguards are equipped with
adjustable supports that enables you to reduce the
play when pulling up or pushing down the tubes.
Tighten or loosen the screws (F) in the four cor-
ners as needed.
Take care not to loosen the two middle screws.
These attach the supports to the frame.
Take care that your fingers do not get caught
between armrest/mudguard and tyre.
17