Brakes - Invacare XLT Power U-front Service Manual

1.
Tool: 5 mm Allen key
2.
3.
4.
18

BRAKES

Adjusting the brake
1. Check that the tyres are inflated to the correct
air pressure as indicated on the side of the tyre.
Then use an Allen key to loosen the screws (A)
and slide the brake and brake attachement to the
desired position and tighten. The correct distance
A
between the brake pin (B) and the tyre, when the
brake is disengaged, is approx. 15 mm. The brake
B
pin should be in a horizontal position.
Incorrect adjustments or use of the brake can
reduce their performance.
2. Using the Standard brake
Apply the brake by pushing the brake lever for-
wards until it reaches the stopper.
Release the brake by pulling back the brake
lever.
Take care not to trap your fingers between
brake shaft and tyre.
When the standard brake is applied, the brake lever
can be pushed backwards without disengaging the
brakes.
This is to prevent the brakes from accidentally dis-
engaging during transfer to and from the wheelchair.
3. Using the Performance brake
Apply the brake by pushing the brake lever for-
wards until it reaches the stopper.
Release the brake by pulling back the brake
lever.
Take care not to trap your fingers between
brake shaft and tyre.
4. Using the Active brake
Apply the brake by pulling the brake lever forwards
(on the side of, or between your legs) until it
reaches the stopper.
Release the brake by pushing the brake lever back
(on the side of, or between your legs).
Take care not to trap your fingers between
brake shaft and tyre.
INVACARE XLT Service Manual
®