User Instructions On The First Boot Process After Loading A Standard Image (V2.2 Or Earlier Only); System Settings Change Message - Wyse 9450XE Reference Manual

User Instructions on the First Boot Process After Loading a Standard Image
(v2.2 or Earlier Only)
If you are running version 2.2 or earlier, you must follow these important instructions when
imaging the Winterm
from the Wyse Web site.
Note
When performing a mass distribution of a custom device image that has
been created with Rapport, certain devices will require unique preparation
prior to image creation and distribution. Please contact the device
manufacturer for more detailed information.
The Winterm
first boot after imaging. Failure to follow these instructions may result in system corruption.
You must not close the DOS window that is present during the process; the DOS window
will close automatically.
Event: The System Settings Change message may appear shortly after the first boot,
depending on the specific hardware configuration of the thin client.
• The New Hardware Found message displays in the system tray (lower right hand
corner of the screen).
• The System Settings Change message prompts for a system restart.
Figure 30 System Settings Change message
Action: If this System Settings Change message appears, click No. Do not interrupt the
thin client while it is automatically running through configuration and reboot.
TM
9 series Thin Clients with the standard XPe image downloaded
TM
9 series Thin Clients automatically run through the configuration steps on
59