Wireless Lan Settings; Peripherals; Printers - Wyse 9450XE Reference Manual

Wireless LAN Settings

If Wyse USB 802.11b hardware is installed on the thin client, double-clicking the Wireless
LAN Settings icon in the administrator Control Panel allows you to customize wireless
LAN settings (such as the wireless network ID, and so on).
Note
The Wireless LAN Settings icon is available only in the administrator Control
Panel and is for the specific Actiontec USB wireless device only.
The wireless LAN settings made using this icon are not applied to any other
wireless cards (such as Cisco 350 and Orinoco Silver).
Any non-Actiontec adapters must be configured through Start | Control
Panel | Network Connections or through the device manager.

Peripherals

Depending on the ports available on the thin client (see "Model Summary" on page 4), the
thin client can provide services through a USB port, a serial port, an LPT port, or a
PCMCIA card plugged-in to the back of the thin client (if the appropriate software is
installed).
Add-ons for other services (available from Wyse) can be installed using Rapport Remote
Administrative Software. For information on using Rapport Remote Administrative
Software, refer to "Remote Administration and Firmware Upgrades" on page 58.

Printers

A universal print driver is installed on the thin client to support text-only printing to a
locally-connected printer.
To print full text and graphics to a locally-connected printer, install the driver provided by
the manufacturer according to the instructions. Be sure to flush the Enhanced Write Filter
cache to save the installation. For procedures on flushing the cache, refer to "Enhanced
Write Filter" on page 43.
Printing to network printers from ICA and RDP applications can be achieved through print
drivers on the servers.
Note
Printing to a locally-connected printer from an ICA or RDP session using the
print drivers of the server produces full text and graphics functionality from
the printer. To do this, you must install the print driver on the server and the
text only driver on the thin client according to the procedures in "Adding
Printers."
Adding Printers
To install the print driver on the server and the text only driver on the thin client:
1. Connect the printer to the parallel port.
2. Click Start | Settings | Printers and Faxes.
3. Double-click Add a printer to open the Add Printer Wizard.
41