S35 Nfu Steering Lever; F1/2 Remote Control; Figure 4-18 S35 Connection To Junction Unit; Figure 4-19 F1/2 Connection - Simrad AP35 Instruction Manual

Simrad AP35 Autopilot

4.15 S35 NFU Steering Lever

The unit is mounted to bulkhead or panel by two screws from the front. The
cable is connected to the junction unit according to Figure 4-18. Interchange
the port and stbd wires to the screw terminals in the junction unit if
necessary to make the direction of the lever movement coincide with the
direction of the rudder movement.
The unit is opened by removing the three screws on the back cover. Inside
are two sets of micro-switches, a printed circuit board with a plug-in
terminal, and a jumper strap.

4.16 F1/2 Remote Control

This handheld remote control with 10 m (30 ft.) cable is connected to the
control unit as shown in Figure 4-19.
60
S35
STEERING LEVER

Figure 4-18 S35 connection to Junction unit

F1/2
REMOTE CONTROL

Figure 4-19 F1/2 connection

JUNCTION UNIT
PO WER PC B
TB1 TB2 TB3 TB4 TB5
TB6
N O T E!
D i s r e g a r d t h e co l o r c o d e
o n t h e t e r m i n a l l a b e l .
JUNCTION UNIT
POWER PC B
TB 1 TB 2 TB3 TB4 TB5
TB6
TB7
REMOTE
TB7
Vio Bro B e i
REMOTE
22083083H