Connecting A Solenoid Valve; Control Unit; Panel Mounting; Bracket Mounting - Simrad AP35 Instruction Manual

Simrad AP35 Autopilot

Connecting a solenoid valve

4.10 Control unit

Avoid mounting the control unit(s) where it is easily exposed to sunlight, as
this will shorten the lifetime of the display.

Panel mounting

• Make a panel cut-out of 210x102 mm.
• Use the supplied fastening device to
• Connect the Robnet cables to the control

Bracket mounting

• Mount the two bracket halves to the Control unit.
• Temporarily bolt together the other two halves of the bracket to the two
• Hold the Control unit in place by hand and mark the 4 holes for the fixing
54
SOLENOID
VALVE
Sol.
Sol. Sol. gnd

Figure 4-10 Connecting a solenoid valve

fasten the control unit to the panel. See
Figure 4-11
unit connectors (See note on next
page).

Figure 4-11 AP35 Panel mounting

other halves.
screws on the mounting surface.
JUNCTION UNIT
POWER PCB
TB1 TB2 TB3 TB4 TB5
TB6 TB7
22083083H