Troubleshooting; Fault Indicators Td70.1 - Asko TD70 Service Manual

Service Manual TD70

Troubleshooting

Fault indicators TD70.1

In the case of a fault the following fault indicators are shown.
L4
Panel type A
Auto Dry
Auto Extra Dry
S1 L3 L2
Indication
The light to the left of the
Start button flashes
The light above the Start
button flashes
After carrying out corrective actions as above, reset the fault indication on the display by switching off the machine
at the main power switch.
L4
Panel type B
S1 L3 L2
LCD
F10 is shown on the display The microswitch is opened when a
F29 flashes on the display
F30 is shown on the display The program cycle time exceeds 200
After carrying out corrective actions as above, reset the fault indication on the display by switching off the machine at
the main power switch.
L7
Auto Normal Dry
Auto Iron Dry
J1 L9 L8
Cause
The microswitch is opened when a
full condensed water tank is detected.
Detection begins 30 seconds after the
program starts. If the microswitch is open
>30 seconds the program cycle is stopped.
The program cycle time exceeds 200
minutes. The cycle is stopped and the
program is reset.
High ambient temperature combined
with low heater output and low drying
temperature leads to poor condensation
formation.
Poor condensation due to blocked
external air
L7
J1 L9 L8
Cause
full condensed water tank is detected.
Detection begins 30 seconds after the
program starts. If the microswitch is open
>30 seconds the program cycle is stopped.
minutes. The cycle is stopped and the
program is reset.
High ambient temperature combined
with low heater output and low drying
temperature leads to poor condensation
formation.
Poor condensation due to blocked
external air
S4
L24 L29
Action
Check whether the customer has:
• Emptied the tank and restarted the machine.
Service action:
• Clean hoses and check drainage pump
voltage and resistance.
• Check that the float has not got "stuck" and
check the function of the microswitch.
Check whether the customer has:
• Tried spinning at a higher speed.
• Had the machine switched off for 30 minutes
before restarting.
• Good ventilation in the room.
Service action:
• Ensure that the external air has free passage.
S3 S4 L31
/
L18 L24 L29
Action
Check whether the customer has:
• Emptied the tank and restarted the machine.
Service action:
• Clean hoses and check drainage pump
voltage and resistance.
• Check that the float has not got "stuck" and
check the function of the microswitch.
Check whether the customer has:
• Cleaned the evaporator filter (net filter
+ foam filter) and the evaporator.
Check whether the customer has:
• Tried spinning at a higher speed.
• Had the machine switched off for 30 minutes
before restarting.
• Good ventilation in the room.
Service action:
• Ensure that the external air has free passage.
S7 L33 S11 L34
L32
T 7 4 3 C B U T T E R F L Y
L37 S10 L36
S7 LCD S11
S9 S10
L35
D R Y I N G