Troubleshooting; The Machine Will Not Start; The Machine Loses All Power During A Programme; The Machine Leaks Water - Asko Professional TDC145HPS Operating Instructions Manual

TROUBLESHOOTING

NOTE!
When starting the tumble dryer for the fi rst time or
after a long period without use, you may notice a slight
thumping noise. This noise is completely normal and
will disappear after a few loads.

THE MACHINE WILL NOT START

Check
• that the door is properly closed.
• that the main power switch is on.
• that the plug is connected.
• that the main fuses have not blown.
THE MACHINE LOSES ALL POWER
DURING A PROGRAMME
Contact the service division.

THE MACHINE LEAKS WATER

Check that the autofi lter and its seal are installed
correctly and not faulty.

DRYING TAKES TOO LONG

• Check that the lint fi lter is not blocked. See the Care
and cleaning chapter.
• Empty the condensed water container. Clean the
evaporator fi lter (net fi lter + foam fi lter), evaporator, lint
fi lter and autofi lter, see chapter Care and cleaning.
16

ERROR MESSAGES

• If Over Flow appears on the display, the condensed
water container is full or the evaporator fi lter is
blocked. Empty the container, clean the fi lter and
restart the machine. See the Care and cleaning
chapter.
• Read Drying takes too long in this chapter if Max
program time appears on the display.
• If Clean Lint Filter appears on the display, clean the
lint fi lter.
• If Clean condenser appears on the display, clean the
evaporator. See the Care and cleaning chapter.
• If Clean auto fi lter appears on the display, clean the
auto fi lter. See the Care and cleaning chapter.
• Call the service division if Thermistor fault appears on
the display.
• Press the Stop button to close any error messages.