Troubleshooting; The Machine Will Not Start; The Machine Loses All Power During A Programme; The Machine Leaks Water - Asko T884HPXL Operating Instructions Manual

TROUBLESHOOTING

NOTE!
When starting the tumble dryer for the fi rst time or
after a long period without use, you may notice a slight
thumping noise. This noise is completely normal and
will disappear after a few loads.

THE MACHINE WILL NOT START

Check:
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been selected.
To cancel Delayed Start, press the Stop button for
three seconds.
• that the plug is connected.
• that the main fuses have not blown.
THE MACHINE LOSES ALL POWER
DURING A PROGRAMME
Contact the service division.

THE MACHINE LEAKS WATER

Check that the autofi lter and its seal are installed
correctly and not faulty.
WARNING!
If the lint fi lter not is cleaned regularly, the machine's
automatic overheating cut-out may be triggered
because of to high temperature. The heaters in the
machine will then switch off and the drum will continue
to spin to cool down the machine.
Call the service division if:
• Heating fault appears on the display.
• Max program time is shown frequently in the display
and the laundry does not get dry. (Overheating
protection may have been tripped.)

DRYING TAKES TOO LONG

• Check that the lint fi lter is not clogged (see the Care
and cleaning chapter).
• Empty the condensed water container. Clean the
evaporator fi lter (net fi lter + foam fi lter), evaporator, lint
fi lter and autofi lter, see chapter Care and cleaning.
18
Customer Care Center, 1-800-898-1879, www.askousa.com

ERROR MESSAGES

• If Over Flow appears on the display, the condensed
water container is full or the evaporator fi lter is
blocked. Empty the container, clean the fi lter and
restart the machine. See the Care and cleaning
chapter.
• Read Drying takes too long in this chapter if Max
program time appears on the display.
• If Clean Lint Filter appears on the display, clean the
lint fi lter.
• If Clean condenser appears on the display, clean the
evaporator. See the Care and cleaning chapter.
• If Clean auto fi lter appears on the display, clean the
auto fi lter. See the Care and cleaning chapter.
• Call the service division if Thermistor fault appears on
the display.
• Press the Stop button to close any error messages.