Job Tracking Setting - Panasonic Workio DP-C262 Security Manual

Job Tracking Setting

This enables or disables Job Tracking. If Job Tracking is enabled, also set the type of log to record and the
Email address to which it is to be sent.
Note:
Before performing this setup, you fi rst need to register the destination Email address for the log in the address book.
Furthermore, change the setting of the Fax Forward (Fax Parameter No. 54, Fax Forward) parameter to Invalid.
Set the POP Parameters so as to receive the emails automatically when using the Job Tracking function. Otherwise,
your machine cannot receive any emails.
Make sure that the Fax Parameters are NOT set as below.
Auto POP Receive (Fax Parameter No. 147) : Invalid
POP Timer (Fax Parameter No. 146)
The Job Tracking Setting is enabled when the Fax and/or Scan is selected on the Authentication Setting (see page 10 ).
Press the Function key.
Select "Fax/Email Settings" .
Select "04 Key Operator Mode" .
20
: 0 minute
Enter the Key Operator's ID Code (4 digits),
and then select "OK" .
Select "01 Fax Parameters" .