HYOSUNG ST7 Owner's Manual page 41

5. Remove the three nuts
engine oil filter cap
6. Replace the engine oil filter
one.
CAUTION
Insert the filter so that surface of the fil-
ter hole turn toward the engine.
ENGINE OIL FILTER INSTALLATION
INSERTED
DIRECTION
HYOSUNG
16510HN910
holding the
in place.
with a new
LUSTER
MATERIAL
OUTSIDE
When install the engine oil filter, neces-
sarily, "HYOSUNG" character and
"16510HN910" part's NO. be installed
toward the outside, otherwise can dam-
age the engine.
WARNING
Engine oil and exhaust pipes can be hot
enough to burn you.
Wait until the oil drain plug and exhaust
pipes are cool enough to touch with
bare hands before draining oil.
WARNING
New and used oil can be hazardous.
Children and pets may be harmed by
swallowing new or used engine oil or
solvent. Continuous contact with used
engine oil has been found to cause skin
cancer in laboratory animals. Brief con-
tact with used oil or solvent may irritate
skin.
Keep new and used oil and solvent
away from children and pets.
Wear a long-sleeve shirt and water-
proof gloves.
Wash with soap if oil or solvent con-
tact your skin.
7. Before replacing the engine oil filter cap
be sure to check that the engine oil filter
spring and the "O" ring
correctly. Use new "O" ring each time the
engine oil filter is replaced.
8. Replace the oil filter cap
nuts securely but do not over tighten them.
40
CAUTION
are installed
and tighten the
,