Right Handle Switches - HYOSUNG ST7 Owner's Manual

RIGHT HANDLE SWITCHES

ENGINE STOP SWITCH
" " Position : Using when dangerous
condition of falling down during
drive and others or engine stop
suddenly. The ignition circuit is
off. The engine cannot start or
run.
" " Position : Using when need oper-
ation of engine as drive and oth-
ers. The ignition circuit is on and
the engine can run.
WARNING
Do not operate the engine stop switch
into the " " position while driving at
one's pleasure.
FRONT BRAKE LEVER
The front brake is applied by squeezing
t h e b r a k e l e v e r g e n t l y t o w a r d t h e
throttlegrip.
The front brake be anxious about
motorcycle falling down when braking
suddenly as disk brake system.
The brake lamp will come on when the
lever is squeezed.
WARNING
Apply the brake lightly and with great
care on slippery surfaces to avoid skid-
ding.
THROTTLE GRIP
Engine speed is controlled by position of
the throttle grip. Turn it toward you to
increase engine speed. Turn it away from
you to decrease the engine speed.
WARNING
Avoid turning the throttle grip during
brakes.
HAZARD WARNING SWITCH
" " : All four turn signal lamp and
indicator lamp will flash simul-
taneously when the switch is
turned on with the ignition
switch in "ON" position.
" " : The turn signal lamp and indi-
cator lamp go off.
Use the hazard warning lamps to warn
other traffic during emergency parking or
when your vehicle could otherwise become
a traffic hazard.
Put out the hazard warning switch
promptly after used.
If the motorcycle ride with the hazard
warning switch turned on condition,
other driver confuse and the battery's
service life is shortened as electrical
consumption.
28
CAUTION