HYOSUNG Karion Owner's Manual page 58

CLEANING PROCEDURE
A thorough cleaning of your motorcycle is
a necessary part of maintenance and will
help keep your motorcycle looking and
performing its best. Proper cleaning can
also extend the life of your motorcycle.
It is important to clean and inspect your
motorcycle after every ride if it is used in
mud, brush, grass, water, salt water, or very
dusty conditions.
The build-up of mud, brush, grass, etc,
especially on the engine and exhaust
system, can reduce engine cooling, conceal
damage, or increase wear of certain parts. It
is important to remove all debris during
cleaning.
CAUTION
High pressure washers can damage
your motorcycle.
High pressure washers such as those
found at coin-operated car washes have
enough pressure to damage the parts of
your motorcycle. It may cause rust,
corrosion and increase wear.
Do not use high pressure washers to
clean your motorcycle.
★ ★ WASHING YOUR motorcycle
With some care, your motorcycle can be
washed in a similar manner to washing an
automobile.
N O T E
Avoid spraying or allowing water to flow
over the following places :
● ● Spark plug
● ● Fuel tank cap
● ● Carburetor
Use a garden hose at low pressure to
remove the majority of dirt or other debris.
Hand wash your motorcycle with a mild
soap or detergent and water. Try to
thoroughly remove all dirt and debris without
excessive water pressure. Cloth rags,
washing mitts or cleaning brushes can be
used, be careful with brushes as they may
scratch plastic or painted surfaces. Rinse
the motorcycle thoroughly with clean water.
Dry all areas using a chamois or soft
absorbent cloth.
★ ★ INSPECTION AFTER CLEANING
Remove the rags or wrapping from the
exhaust pipe. For extended life of your
motorcycle, lubricate according to
GENERAL LUBRICATION section.
Operating motorcycle with wet brakes
can be hazardous.
Wet brakes may not provide as much
stopping power as dry brakes. This
could lead to an accident.
Test your brakes after washing
motorcycle, while riding at slow speed. If
necessary, apply brakes several times
to let friction dry out the linnings and
pads.
Follow the
INSPECTION BEFORE RIDING section
to check your motorcycle for any problems
that may have arisen during your last ride.
탑탔
WARNING
procedures in the