HYOSUNG Karion Owner's Manual page 35

BREAK-IN
The opening explains how important
proper break-in is to achieve maximum life
and performance from your new Hyosung.
The following guidelines explain proper
break-in procedures.
★ ★ MAXIMUM THROTTLE OPENING
RECOMMENDATIONS
The table below shows the maximum
throttle opening recommendation during the
break-in period.
Initial 800km (500miles)
Up to 1,600km (1,000miles)
★ ★ VARY THE ENGINE SPEED
The engine speed should be varied and
not held at a constant speed.
This allows the parts to be loaded with
pressure and then unloaded, allowing the
parts to cool.
This aids the mating process of the parts.
It is essential that some stress be placed on
the engine components during break-in to
ensure this mating process.
Do not, though, apply excessive load on
the engine.
★ ★ BREAKING IN THE NEW TIRES
New tires need proper break-in to assure
maximum performance, just as the engine
does.
Wear in the tread surface by gradually
increasing your cornering lean angles over
Less than 1/2 throttle
Less than 3/4 throttle
the first 160km(100miles) before
attempting maximum performance. Avoid
hard acceleration, hard cornering, and hard
braking for the first 160km(100miles).
WARNING
Failure to perform break-in of the tires
could cause tire slip and loss of control.
Use extra care when riding on new tire.
Perform proper break-in of the tire as
described in this section and avoid hard
acceleration, hard cornering, and hard
braking for the first 160km(100miles).
★ ★ ALLOW THE ENGINE OIL TO
CIRCULATE BEFORE RIDING
Allow sufficient idling time after warm or
cold engine start up before applying load
or reviving the engine. This allows time
for the lubricating oil to reach all critical
engine components.
★ ★ OBSERVE YOUR FIRST, AND
MOST 1,000
The 1,000km (600miles) service is the
most important service your motorcycle
will receive.
During break-in procedures all of the
engine components will have worn in
and all of the other parts will have seated
in.
All adjustments will be restored, all
fasteners will be tightened, and the dirty
engine oil and engine oil filter will be
replaced.
Timely performance of the 1,000km
(600miles) service will ensure optimum
service life and performance from the
engine.
탉탐
SERVICE