HYOSUNG Karion Owner's Manual page 48

1. Place the motorcycle on the jack or block.
2. Loosen the axle nut
3. Adjust the slack in the drive chain by
adjuster as the lock nut
toward the left and right.
4. For alignment of the rear sprocket and
the front sprocket, there are reference
mark on the same position.
After aligning and adjusting the slack in
the drive chain to 20~30mm (0.79~1.18
in), retighten the axle nut securely and
perform a final inspection.
CAUTION
The drive chain for this motorcycle is
made of the special material.
The chain should be replaced with a
428HO.
Use of another chain may lead to
premature chain failure.
CAUTION
The drive chain should be inspected
every time before riding.
Excessive chain slack could cause the
chain to come off the sprockets and
result in accident or serious engine
damage.
WARNING
Be careful not to touch the muffler when
it is hot : a hot muffler can burn you.
.
turning
◉ ◉ DRIVE CHAIN CLEANING AND OILING
If the drive chain become dirty, the drive
chain and the sprocket is wore easily. This
times, clean the drive chain with solvent and
oil every 1,000km with lubricating oil or
motor oil.
탐탔