REPLACEMENT OF THE LAMP
Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than rules may
cause to excessive at the electric system or
to damage the lamp.
NAMES
HI
Head lamp
LO
Brake / Tail lamp
Turn signal lamp
License lamp
◉ ◉ HEAD LAMP
1. Remove the two screw
and the headlamp assembly.
CAPACITY
12V-35W× 1
12V-35W× 1
12V-21/5W× 1
12V-10W× 4
12V-5W× 1
�
(right and left)
2. Disconnect the headlamp coupler.
3. Remove the dust cover
spring
.
4. After removing the bulb at the socket,
replace the new bulb.
5. To install the headlamp, reverse the
above sequence.
The use of a lamp other than rules may
cause to occur the vehicle fire and to
damage electric parts.
Surely use only the lamp of proper
capacity.
◉ ◉ TURN SIGNAL LAMP
1. Remove the lens by removing the screw.
탑탐
�
and socket
CAUTION
�