Table of Contents
Advertisement
Factory default settings
Command Line Interface (CLI)
Factory default settings
Configuring NAT/Route mode
30
The CLI is a full-featured management tool. Use it to configure the administrator
password, the interface addresses, the default gateway, and the DNS server
addresses.
Requirements:
•
The serial connector that came packaged with your FortiCarrier-5001A board.
•
Terminal emulation application (for example, HyperTerminal for Windows) on
the management computer.
The FortiCarrier-5001A unit ships with a factory default configuration. The default
configuration allows you to connect to and use the FortiCarrier-5001A web-based
manager to configure the FortiCarrier-5001A board onto the network. To configure
the FortiCarrier-5001A board onto the network you add an administrator
password, change the network interface IP addresses, add DNS server IP
addresses, and, if required, configure basic routing.
Table 7: FortiCarrier-5001A factory default settings
Operation Mode
Administrator Account
port1 IP/Netmask
port2 IP/Netmask
Default route
Primary DNS Server:
Secondary DNS Server:
Note: At any time during the configuration process, if you run into problems, you can reset
the FortiCarrier-5001A board to the factory defaults and start over. From the web-based
manager go to System > Status find System Operation at the bottom of the page and
select Reset to Factory Default. From the CLI enter execute factory reset.
Use
Table 8
to gather the information you need to customize NAT/Route mode
settings for the FortiCarrier-5001A security system. You can use one table for
each board to configure.
NAT/Route
User Name: admin
Password: (none)
192.168.1.99/24
192.168.100.99/24
Gateway: 192.168.100.1
Device: port2
65.39.139.53
65.39.139.53
FortiCarrier-5001A Security System Guide
Quick Configuration Guide
01-400-91945 -20090223
Advertisement
Table of Contents
