Fortinet FortiCarrier-5001A-DW Manual page 17

Hardware installation
6
7
8
9
FortiCarrier-5001A Security System Guide
01-400-91945 -20090223
Caution: To avoid damaging the lock, make sure you squeeze the handles fully to unlock
them before opening. The handles should pop easily out of the board front panel.
Alignment Pin
Handle
Open
Lock
Insert the FortiCarrier-5001A board into the empty slot in the chassis.
Carefully guide the board into the chassis using the rails in the slot.
Insert the board by applying moderate force to the front faceplate (not the
handles) to slide the board into the slot. The board should glide smoothly into the
chassis slot. If you encounter any resistance while sliding the board in, the board
could be aligned incorrectly. Pull the board back out and try inserting it again.
Slide the board in until the alignment pins are inserted half way into their sockets
in the chassis.
Turn both handles to their fully-closed positions.
The handles should hook into the sides of the chassis slot. Closing the handles
draws the FortiCarrier-5001A board into place in the chassis slot and into full
contact with the chassis backplane. The FortiCarrier-5001A front panel should be
in contact with the chassis front panel. The right (bottom) handle locks into place.
As the handles closed power is supplied to the board. If the chassis is powered on
the IPM LED starts flashing blue. If the board is aligned correctly, inserted all the
way into the slot, and the handles are properly closed the IPM LED flashes blue
for a few seconds. At the same time the STATUS LED flashes green, the interface
LEDs flash amber, and the ACC LED starts flashing green. After a few seconds
the IPM LED goes out and the FortiCarrier-5001A firmware starts up. During start
up the STATUS LED may continue to flash green. Once the board has started up
and is operating correctly, the front panel LEDs are lit as described in
Table 4: FortiCarrier-5001A normal operating LEDs
LED State
Off (Or flashing green when the system accesses the
ACC
FortiCarrier-5001A flash disk.)
OOS Off
(Out of
Service)
Green
Power
Off
Status
Off
IPM
Inserting a FortiCarrier-5001A board
Alignment Pin
Handle
Table 4.
17