Table of Contents
Advertisement
FortiCarrier-5001A mounting components
FortiCarrier-5001A mounting components
14
Figure 6: Location of SW11 on the FortiCarrier-5001A board
Location of SW 11
Factory Default (Shelf Manager Required)
ON
1 Off
2 On
SW11
3 Off
4 Off
1
2
3 4
Standalone Mode for FortiGate-5020
(no Shelf Manager)
1 Off
ON
2 On
SW11
3 On
4 Off
1
2
3 4
4
If required, change SW11 to the correct setting.
5
Insert the FortiCarrier-5001A board into a chassis and verify that the board starts
up and operates correctly.
For inserting instructions, see
To install a FortiCarrier-5001A board you slide the board into an open slot in the
front of an ATCA chassis and then use the mounting components to lock the
board into place in the slot. When locked into place and positioned correctly the
board front panel is flush with the chassis front panel. The board is also connected
to the chassis backplane.
Note: FortiCarrier-5001A boards are horizontal when inserted into a FortiGate-5050
chassis and vertical when inserted into a FortiGate-5140 chassis. The inserting and
removing procedures are the same in either case. For clarity the descriptions in this
document refer to the left (top) and right (bottom) mounting components.
To position the board correctly you must use the mounting components shown in
Figure 7
for the right (bottom) side of the front panel and in
(top) side of the front panel. The FortiCarrier-5001A mounting components align
the board in the chassis slot and are used to insert and eject the board from the
slot.
FortiCarrier-5001A
board (top view)
FortiCarrier-5001A
Front Faceplate
"Inserting a FortiCarrier-5001A board" on page
FortiCarrier-5001A Security System Guide
Hardware installation
15.
Figure 8
for the left
01-400-91945 -20090223
Advertisement
Table of Contents
