Table of Contents
Advertisement
Troubleshooting
26
To remove and reset an AMC module
1
Attach an ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2
Remove the FortiCarrier-5001A board from the chassis slot.
See
"Removing a FortiCarrier-5001A board" on page
completely remove the FortiCarrier-5001A board from the slot; however the board
should be disconnected from power.
3
With the FortiCarrier-5001A left (top) handle fully open, pull the latch on the AMC
module front panel to open the latch and pull the AMC module out of the
FortiCarrier-5001A front panel AMC opening.
4
With the FortiCarrier-5001A left (top) handle fully open, re-insert the AMC module
into the FortiCarrier-5001A front panel AMC opening.
Make sure the AMC module is inserted correctly into the opening.
5
Close the latch on the AMC front panel.
6
Insert the FortiCarrier-5001A board into the chassis slot.
Both the AMC module and the FortiCarrier-5001A board should start up. If both
the FortiCarrier-5001A board and the AMC module are functioning normally, the
front panel LEDs will appear as described in
page
18.
7
If this does not solve the problem, contact Fortinet Technical Support.
Hardware installation
18. You do not have to
Table 4 on page 17
and
Table 5 on
FortiCarrier-5001A Security System Guide
01-400-91945 -20090223
Advertisement
Table of Contents
