Table of Contents
Advertisement
Removing a FortiCarrier-5001A board
Removing a FortiCarrier-5001A board
18
If you have installed an AMC module in the FortiCarrier-5001A board, the AMC
LEDs are lit as described in
Table 5: FortiGate AMC module normal operating LEDs
LED
State
HS
Off
OOS
Off
PWR
Amber
OT
Off
If the board has not been inserted properly the IPM LED changes to solid blue and
all other LEDS turn off. If this occurs, open the handles, slide the board part way
out, and repeat the insertion process.
10
Once the board is inserted correctly, fully tighten the retention screws to lock the
FortiCarrier-5001A board into position in the chassis slot.
Tighten
The following procedure describes how to correctly use the FortiCarrier-5001A
mounting components described in
page 14
to remove a FortiCarrier-5001A board from an ATCA chassis slot.
FortiCarrier-5001A boards are hot swappable. The procedure for removing
a FortiCarrier-5001A board from a chassis slot is the same whether or not the
chassis is powered on.
To remove a FortiCarrier-5001A board from a chassis slot
Caution: Do not carry the FortiCarrier-5001A board by holding the handles or retention
screws. When inserting or removing the FortiCarrier-5001A board from a chassis slot,
handle the board by the front panel. The handles are not designed for carrying the board. If
the handles become bent or damaged the FortiCarrier-5001A board may not align correctly
in the chassis slot.
To complete this procedure, you need:
•
An ATCA chassis with a FortiCarrier-5001A board installed
•
An electrostatic discharge (ESD) preventive wrist strap with connection cord
Table
5.
Retention
Screw
"FortiCarrier-5001A mounting components" on
FortiCarrier-5001A Security System Guide
Hardware installation
01-400-91945 -20090223
Advertisement
Table of Contents
