Table of Contents
Advertisement
Installing and removing AMC modules
Inserting AMC slot filler panels
22
Table 6: FortiGate AMC module LEDs
LED
State
ACT
Flashing
Green or
Amber
Off
ACT/RDY Amber
Off
PORT
Off
This section describes:
•
Inserting AMC slot filler panels
•
Inserting AMC modules
•
Removing AMC modules
The following procedure describes how to install a slot filler panel in the
FortiCarrier-5001A front panel AMC opening. The FortiCarrier-5001A-DW board
includes one AMC double-width slot filler panel.
Caution: Do not operate the FortiCarrier-5001A board with an open AMC opening. For
optimum cooling performance and safety, the AMC opening must contain a slot filler panel
or a FortiGate AMC module.
Caution: Because the FortiCarrier-5001A board does not support hot swapping AMC
modules, you must eject the FortiCarrier-5001A board from its chassis slot and completely
open the handles before inserting or removing AMC modules or slot filler panels.
To install an AMC slot filler panel
To complete this procedure, you need:
•
FortiCarrier-5001A board with an empty AMC slot
•
An electrostatic discharge (ESD) preventive wrist strap with connection cord
Caution: FortiCarrier-5001A boards must be protected from static discharge and physical
shock. Only handle or work with FortiCarrier-5001A boards at a static-free workstation.
Always wear a grounded electrostatic discharge (ESD) preventive wrist strap when
handling FortiCarrier-5001A boards.
1
Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist
strap terminal.
2
Eject the FortiCarrier-5001A board from the chassis slot.
3
With the FortiCarrier-5001A left (top) handle fully open, pull the latch on the slot
filler front panel to the extended position.
4
Insert the slot filler panel by applying moderate force to the front faceplate to slide
the slot filler panel into the opening.
The slot filler panel should glide smoothly into the opening. If you encounter any
resistance while sliding the slot filler panel in, the slot filler panel could be aligned
incorrectly. Pull the slot filler panel back out and try inserting it again.
5
Press the latch in the slot filler front panel to lock in the slot filler panel.
Description
Network activity at this interface.
No network activity at this interface.
The module is properly inserted in the FortiGate unit.
The module is not receiving power from the FortiGate unit.
LED currently not in use.
FortiCarrier-5001A Security System Guide
Hardware installation
01-400-91945 -20090223
Advertisement
Table of Contents
