SiBE12-908
TIMER Operation
4
ATTENTION
In the following cases, set the timer again
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
20
Installation / Operation Manual
To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time. (page 7.)
1.
Press "ON TIMER" button.
• "
" is displayed.
"
" blinks.
•
•
"
" and day of the week disappears from LCD.
2.
Press "SELECT" button until the time setting reaches the
point you like.
• Every pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3.
Press "ON TIMER" button again.
2
• "
" and setting time are displayed on the LCD.
• The TIMER lamp lights up.
1, 3
To cancel ON TIMER operation
4.
Press "CANCEL" button.
• "
" and setting time disappears from LCD.
• "
" and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
(Example)
Present time: 23:00
(The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
Operation Manual
85