Daikin CTXU25G2V1B Service Manual page 25

Main Functions
<Forced operation mode>
Forced operation mode will be set by pressing the ON/OFF button for between 5 to 9 sec. while
the unit is not operating.
See page 42 for the detail of "Forced Operation Mode".
Note: When the ON/OFF button is pressed for 10 sec. or more, the operation will be stopped.
1.13.6 Titanium Apatite Photocatalytic Air-Purifying Filter
This filter combines the Air Purifying Filter and Titanium Apatite Photocatalytic Deodorizing
Filter in a single highly effective unit. The filter traps microscopic particles, decompose odours
and even deactivates bacteria and viruses. It lasts for 3 years without replacement if washed
about once every 6 months.
1.13.7 Air Filter (Prefilter)
The air filter net is impregnated with a safe, odorless mold preventative to make the filter
virtually immune to mold.
1.13.8 Auto-restart Function
Even if a power failure (including one for just a moment) occurs during the operation, the
operation restarts in the condition before power failure automatically when power is restored.
(Note) It takes 3 minutes to restart the operation because the 3-minute standby function is
activated.
22
Push this button once to start operation. Push once again to stop it.
This button is useful when the remote controller is missing.
The operation mode refers to the following table.
Mode
Heat Pump AUTO
In the case of multi system operation, there are times when the unit does not activate with
this button.
Temperature setting
°
25 C
SiBE12-908
Airflow rate
AUTO
Function and Control