Daikin CTXU25G2V1B Service Manual page 79

Operation Manual
Adjusting the 3-D airflow direction
T o start 3-D airflow
1. 3. Press the "SWING
display will light up and the flap and louvers will move in turn.
To cancel 3-D airflow
2. 4. Press either the "SWING
COMFORT AIRFLOW operation
• Check COMFORT AIRFLOW operation in the section of "COMFORT AIRFLOW Operation" and "INTELLIGENT EYE Operation". (page 15.)
NOTE
Notes on flaps an d louvers angles
• When "SWING" button is selected, the flaps swinging range depends on the operation
mode. (See the figure.)
3-Dimensional (3-D) airflow
• Using 3-dimensional airflow circulates cold air, which tends to collected at the bottom of
the room, and hot air, which tends to collect near the ceiling, throughout the room,
preventing areas of cold and hot developing.
ATTENTION
• Always use a remote controller to adjust the angles of the flaps and louvers. If you attempt
to move it forcibly with hand when it is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the louvers angles. In side the air outlet, a fan is
rotating at a high speed.
76
" button and the "SWING
" button or the "SWING
" button: the " " and "
" button.
In DRY mode or
COOL mode
COMFORT AIRFLOW 5˚
(page 15.) 15˚
50˚
Upper limit
Lower limit
Stop operation
In HEAT mode
Stop operation
30˚
Upper limit
70˚
Lower limit
80˚
COMFORT AIRFLOW (page 15.)
In FAN mode
5˚
Upper limit
80˚
Lower limit Stop operation
Installation / Operation Manual
SiBE12-908
"
11