Transferring The Ups To Bypass Mode; Operating Modes - Eaton Powerware 9125 User Manual

Transferring the UPS to Bypass Mode

NOTE When the UPS is in Bypass mode, Battery mode is not available and the UPS does
not protect against power outages; however, the utility power continues to be passively
filtered by the UPS.
Press the On button for approximately eight seconds to transfer the
UPS to Bypass mode. The
Press the On button again for approximately three seconds to return to
Normal mode.

Operating Modes

Powerware 9125's front panel indicates the UPS status through the UPS
indicators. Figure 14 shows the UPS front panel indicators and controls.
Normal Mode Indicator
Battery Mode Indicator
Bypass Mode Indicator
Test/Alarm Reset Button
EATON Powerware
indicator illuminates.
Off Button On Button
Figure 14. UPS Front Panel
®
9125 Two-in-One UPS (5000/6000 VA) User's Guide
OPERATION
Alarm Indicators (see page 51)
Bar Graph Indicators
Indicator Legend
Unlit
Lit
Flashing
S
164201513 Rev B
www.powerware.com
31