Eaton Powerware 9125 User Manual page 58

TROUBLESHOOTING
Table 11. Troubleshooting Guide
Alarm or Condition Possible Cause
μ
The indicator is not The power cord is not
on; the UPS does not start. connected correctly.
The wall outlet is faulty.
The main utility breaker is off. Verify that the main utility breaker is on.
μ
The indicator is The UPS is in Standby mode.
flashing; power is not
available to your
equipment.
The UPS operates The equipment is not
normally, but some or all of connected to the UPS
the protected equipment is correctly.
not on.
The UPS does not provide The batteries need charging
the expected backup time. or service.
Battery circuit breakers are
in the OFF (O) position.
UPS on battery (see "Battery
Battery
Mode" on page 33 for more
Intermittent audible alarm
information).
The UPS does not detect any
Battery
batteries.
Intermittent audible alarm
Three-minute battery
warning.
Warning - Low Battery
Shutdown imminent.
Shutdown - Low Battery
52
EATON Powerware
www.powerware.com
Action
Check the power cord connections.
Have a qualified electrician test and repair the outlet.
Press the On
connected equipment.
Verify that the equipment is plugged into the UPS
receptacle.
For hardwired models, contact a qualified electrician to
check connections to the power source.
Plug the UPS into a power outlet (apply utility power on
hardwired models) for 24 hours to charge the battery.
After charging the battery, press and hold the
for 3 seconds; then check the
If the
page 41 to replace the battery.
Switch the battery circuit breaker to the ON (
for all connected battery cabinets.
The UPS is powering the equipment with battery power.
Check the bar graph indicators for available battery
capacity and prepare your equipment for shutdown.
Verify that the internal batteries are installed correctly
(see page 16) and that the battery circuit breaker is in the
ON (
Three minutes or less of battery power remains
(depending on load configuration and battery charge).
Prepare for a shutdown. Save your work and turn off your
equipment.
Prepare equipment for shutdown.
®
9125 Two-in-One UPS (5000/6000 VA) User's Guide
|
button to supply power to the
indicator.
indicator is still on, see "UPS Maintenance" on
|
) position.
S
164201513 Rev B
button
|
) position