Dell KY0730481 Installation And Startup Manual page 33

Matchprint Professional Server IIx for Xerox: Hardware Installation and Startup
Patches are read from left to right in a slow, steady manner. The color patches appear on the
screen as they are measured. It should take approximately 6 to 8 seconds to completely scan
one row.
If you move too slowly or too rapidly, patches are not read correctly. Within the calibrate dialog an
X appears on any patch that is miss-read. If this happens, reposition the device on the first patch
of that row and touch the sensor to start the patch reading of that row again. The Instruction box
at the top of the window will indicate any action you must take regarding measurement readings.
To read the last two rows, you will need to move the test form up so the Spectrocam rests on the
black scanner plate.
Note: The Spectrocam times out after 10 minutes of inactivity. Instructions appear directing
the user to restart the calibration process.
If the calibration is successful, the following message appears: "The calibration process was
successful. You may now calibrate another media."
4. Click on OK to return to the calibration window.
Note: Color critical jobs should have each media calibrated separately using the recommended Xerox Color
Xpresssions media. If the user checks the "Apply this calibration to all media types," the same calibration will be
applied to all supported media types. This is not recommended for users with color critical jobs.
2003 Kodak Polychrome Graphics. All rights reserved.
Page 33 of 36