Mercury HP 500 EFI Bravo XR/XZ/III User Manual page 61

POWER TRIM OPERATION - PANEL MOUNT REMOTE CON-
TROL
IMPORTANT: If TRAILER button is held depressed after drive
unit reaches end of upward travel, an internal circuit breaker will
open and pump will stop. Should this happen, release button
and allow motor to cool for about one minute. Circuit breaker
will reset and Power Trim operation may be resumed.
The Bravo heavy duty gimbal does not have a trim limit switch.
Depressing the trim and/or trailer buttons will allow the drive
to be tilted to its full extension without stopping at a preset
trim limit. Manual indicators are recommended to help keep
the operator aware of the drive positioning.
1 Trailer Button: (Not used with Bravo Heavy Duty Transoms)
Press button until drive unit reaches desired height.
2 Trim Up/Out: Press UP on Trim switch until drive unit reaches de-
sired trim position.
3 Lower Drive Unit: Press DOWN on Trim switch until drive unit
reaches desired position.
POWER TRIM OPERATION - CONSOLE MOUNT REMOTE
CONTROL (SINGLE ENGINE VERSION)
4 Trailer Position: (Not used with Bravo Heavy Duty Transoms)
Press button until drive unit reaches desired height.
5 Trim Up/Out: Press UP on Trim switch until drive unit reaches de-
sired trim position.
6 Lower Drive Unit: Press DOWN on Trim switch until drive unit
reaches desired position.
500 EFI Bravo
OPERATION
CAUTION
57