Bottom Of Boat; Inspection Of Power Package; Attention Required After Submersion - Mercury HP 500 EFI Bravo XR/XZ/III User Manual

CA104

Bottom of Boat

To maintain maximum speed, the following conditions of the boat
bottom should be observed:
•
Clean, free of barnacles and marine growth.
•
Free of distortion, nearly flat where it contacts water.
•
Straight and smooth, fore and aft.
ANTIFOULING PAINTS
See Antifouling Paint recommendations and related information on
previous pages.
IMPORTANT: Refer to CORROSION AND CORROSION PRO-
TECTION for additional information.
CA105

Inspection of Power Package

Inspect power package often, and at regular intervals, to help main-
tain its top operating performance, and correct potential problems
before they occur. The entire power package should be checked
carefully, including all accessible engine parts.
1. Check for loose, damaged or missing parts, hoses and clamps;
tighten or replace as required.
2. Check plug leads and electrical leads for damage.
3. Remove and inspect propeller. If badly nicked, bent or cracked,
see your dealer.
4. Repair nicks and corrosion damage on power package exterior
finish. Use Quicksilver spray paints - see your Authorized Mer-
Cruiser Dealer.
CA409

Attention Required After Submersion

•
Before recovery, contact an Authorized MerCruiser Dealer.
•
After recovery, immediate service by an Authorized MerCruiser
Dealer is required to prevent serious damage to power package.
500 EFI Bravo
MAINTENANCE
119