Proxy Registration; Register Expires - LG-Ericsson LIP-8002/8002A Installer's Manual

iPECS
To assign an RTP Start Port:
 Press the Settings (
to section 3.3.
 Press the
digit, or move the cursor to 2.SIP Configuration using the navigation buttons
and press the OK button.
 Press the
digit, or move the cursor to 7.RTP Start Port using the navigation buttons and
press the OK button.
 Input the RTP Start Port using the dial pad and press the OK button to save your entry.
 Move to another parameter with the navigation buttons and continue the session or press the
Settings ( ) button to exit the configuration session.
Changing the RTP Start Port requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.

3.5.2.7 Proxy Registration

If Proxy Registration is set to Yes, the IP Phone will register with the appropriate call or proxy
server upon initial power-up, during a reboot and at periodic intervals based on the timer defined
in section 3.5.2.8.
To enable Proxy Registration:
 Press the Settings (
to section 3.3.
 Press the
digit, or move the cursor to 2.SIP Configuration using the navigation buttons
and press the OK button.
 Press the
button, or move the cursor to 8.Proxy Registration using the navigation
buttons and press the OK button.
 To change, select Yes or No using the Up/Down navigation buttons and press the OK button.
 Move to another parameter with the navigation buttons and continue the session or press the
Settings ( ) button to exit the configuration session.
Changing the Proxy Registration requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.

3.5.2.8 Register Expires

To assure a connection with the proxy or SIP call server, the IP Phone periodically re-registers.
Unless defined by the host server during registration, the Register Expires timer determines the
interval between registration attempts and is set from 0 to 6400 seconds, default 3600 seconds.
To modify the Register Expires timer:
 Press the Settings (
to section 3.3.
) button. If the LCD Menu is locked, use the unlock procedure. Refer
) button. If the LCD Menu is locked, use the unlock procedure. Refer
) button. If the LCD Menu is locked, use the unlock procedure. Refer
25
LIP-8002/8002A
Installer Guide