Provisioning The Lip-8002/8002A - LG-Ericsson LIP-8002/8002A Installer's Manual

iPECS
 Remove the Handset hook from the phone as shown in the figure below. Reverse the hook
and re-install in the IP Phone so that the hook catches the groove in the handset receiver.
 Complete all wiring as described in

2.3 Provisioning the LIP-8002/8002A

LIP-8002/8002A supports 'plug and play' installation employing the automated provisioning
process described in
section 2.1, the IP phone retrieves LAN settings including IP address, subnet mask and default
gateway address from the local DHCP (Dynamic Host Control Protocol) server. In addition, the
IP phone requests address information for the provisioning server where configuration and
software files are maintained. The IP phone downloads the configuration and, if required,
software files from the provisioning server.
registers and subscribes for SIP call services using the information from the configuration files.
Refer to Appendix D
LIP-8002/8002A incorporates means for manual configuration when the automated process is
not fully available. As a minimum, the LIP-8002/8002A requires the information below for
proper operation. When not assigned through the automated provisioning process, manual
entry of the below parameters is required for proper operation.
SIP parameters including:
-
o SIP call server IP address
o Name (SIP user id)
o Authentication user name
o Authentication password
In addition using static IP addressing requires manual entry of the following IP network
configuration data.
o IP address of the IP phone
section
Figure 2.2-1 LIP-8002/8002A Wall Mount Installation
Appendix F. After connecting to the LAN, desktop PC and power, refer to
for more details.
2.1.
When complete, the IP phone automatically
6
LIP-8002/8002A
Installer Guide