MSI MS-6380 User Manual page 71

receiving the signal, when the operating system is ready, the system will
interrupt itself and perform the service required by the I/O device.
CPU Critical Temperature
This item is used to specify a thermal limit for CPU. If CPU temperature
reaches the specified limit, the system will issue a warning to prevent the
CPU overheat problem. Settings: Disabled, 70°C/158°, 75°C/167°F, 80°C/
176°F, 85°C/185°F, 90°C/194°F and 95°C/203°F.
Power Button Function
This feature sets the function of the power button. Settings are:
On/Off
Suspend
After AC Power Loss
This item specifies whether you system will reboot after a power failure or
interrupt occurs. Available options are:
Power Off
Power On
Last State
Wake Up On Ring/LAN
When setting to Enabled, the features allow your system to be awakened
from the power saving modes through an incoming call from the modem or
any incoming signal received via the LAN. Settings: Enabled and Disabled.
Note: You need to install a modem/LAN card supporting power on
function for Wake Up On Ring/LAN function.
Wake Up On PME
When setting to Enabled, the feature allows your system to be awakened
from the power saving modes through any event on PME (Power Manage-
ment Event). Settings: Enabled and Disabled.
The power button functions as normal on/off button.
When you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer is
turned off.
Leaves the computer in the power off state.
Reboots the computer.
Restores the system to the previous status before the
power failure or interrupt occurred.
3-19
AMI BIOS Setup
®