MSI MS-6380 User Manual page 66

Chapter 3
Way and 4-Way.
Burst Length
This setting allows you to set the size of Burst-Length for DRAM. Bursting
feature is a technigue that DRAM itself predicts the address of the next
memory location to be accessed after the first address is accessed. To use
the feature, you need to define the burst length, which is the actual length of
burst plus the starting address and allows internal address counter to
properly generate the next memory location. The bigger the size, the faster
the DRAM performance. Settings: 4 QW and 8 QW.
SDRAM 1T Command
This item controls the SDRAM command rate. Selecting Enabled allows
SDRAM signal controller to run at 1T (T=clock cycles) rate. Selecting
Disabled makes SDRAM signal controller run at 2T rate. 1T is faster than
2T.
Fast Command
This item controls the internal timing of CPU. Selecting Enabled allows CPU
to handle data/instructions at a faster speed.
AGP Mode
The item sets an appropriate mode for the installed AGP card. Settngs are
1x, 2x, 4x and Auto. Select 4x only if your AGP card can support it.
AGP Comp. Driving
This filed is used to adjust the AGP driving force. Selecting Manual allows
you to select an AGP driving force in Manual AGP Comp. Driving. It is
strongly suggested to select Auto to avoid causing any system error.
Manual AGP Comp. Driving
This item specifies an AGP driving force.
AGP Fast Write
The field enables or disables the AGP Fast Write feature. The Fast Write
technology allows CPU to write directly to the graphics card without
3-14