MSI MS-6380 User Manual page 70

Chapter 3
Call VGA at S3 Resuming
Selecting Enabled will make BIOS call VGA BIOS to initialize the VGA card
when system wakes up (resume) from S3 state. The system resume time is
shortened if you disable the function, but system will need AGP driver to
initialize the card. Therefore, if the AGP driver of the VGA card does not
support the initialization feature, the display may work abnormally or not
function after resuming from S3.
USB Wakeup From S3
This item allows the activity of the USB device to wake up the system from
S3 (Suspend to RAM) sleep state. Settings: Enabled and Disabled.
Power Management/APM
Setting to Enabled will activate the Advanced Power Management (APM)
features to enhance power saving modes. Settings: Enabled and Disabled.
Power/Sleep LED
This item configures how the system uses power LED on the case to
indicate the sleep state. Available options are:
Single LED The power LED blinks to indicate the sleep state
Dual LED
Display Activity/IRQ3/IRQ4/IRQ5/IRQ7/IRQ9/IRQ10/IRQ11/IRQ13/
IRQ14/IRQ15
These items specify if the BIOS will monitor the activity of the specified
hardware peripheral or component. If set to Monitor, any activity detected
on the specified hardware peripheral or component will wake up the system
or prevent the system from entering the power saving modes. Settings:
Monitor and Ignore.
Note: IRQ (Interrup Request) lines are system resources allocated
to I/O devices. When an I/O device needs to gain attention of the
operating system, it singals this by causing an IRQ to occur. After
the previous state when an "wake up" event occurs.
without changing its color.
The power LED changes its color to indicate the sleep
state.
3-18