Minolta Di152 Service Manual page 97

Code No.
Allow Paper of same type to be fed from another tray when paper from
one source is empty.
C28 to 33
C20: 1st Tray C21: 2nd Tray C22: 3rd Tray
C23: 4th Tray C25: 5th Tray
(2) Drum Dehumidify Mode (Display: U-2)
• Removes dewdrops that have formed on the surface of the PC Drum.
<Procedure>
1. Hold down the Panel Reset key for 3 seconds.
2. Enter "2" from the 10-Key Pad. (Display: U-2)
3. Press the Start key. The Drum Dry sequence will be stopped after a given period of
time.
(3) Toner Replenisher Mode (Display: U-3)
• Supply of toner is replenished. The replenishing sequence is stopped after a given
period of time or when a required level of toner-to-carrier ratio is recovered.
<Procedure>
1. Hold down the Panel Reset key for 3 seconds.
2. Enter "3" from the 10-Key Pad. (Display: U-3)
3. Press the Start Key.
(4) Custom Size Input Mode (Display: U-4)
• Input the size of the paper loaded in the 1st Tray. (This is necessary when paper of a
nonstandard size is to be used.)
<Procedure>
1. Hold down the Panel Reset key for 3 seconds.
2. Enter "4" from the 10-Key Pad. (Display: U-4)
3. Press the Start key. Then, the Display will show the currently set value (in the FD direc-
tion).
4. Press the Clear key to reset the currently set value.
5. Enter the new value from the 10-Key Pad.
6. Press the Start key. Then, the Display will show the currently set value (in the CD direc-
tion).
7. Press the Clear key to reset the currently set value.
8. Enter the new value from the 10-Key Pad.
9. Press the Start key to validate the values entered.
If a value entered falls outside the specified range (paper size), that entry is rejected and
the old value is restored.
<Exiting the Mode>
• Press the Panel Reset key.
Setting (The default is
<Special Paper Setting>
Setting
Enables Auto Paper (selection). Enables Auto Tray
0
Switching.
1 Disables Auto Paper. Enables Auto Tray Switching.
2 Disables Auto Paper. Disables Auto Tray Switching.
S-9
Highlighted ).
Description
C23: Multiple Bypass Tray