Minolta Di152 Service Manual page 24

No. Part Name
1 Original Cover
2 Original Glass
3 Control Panel
4 Right Inside Cover
5 Front Cover
6 Front Door
7 1st Tray
8 Left Cover
9 Upper Cover
10 Rear Inside Cover
11 ADF Glass
12 Left Hinge
13 Right Hinge
14 Rear Cover
15 Rear Right Cover
Multiple Bypass
16 Cover (when the
option is mounted)
17 Right Door
18 Right Cover
Pull the Original Cover straight up.
Remove no. 18. → Remove two holding brackets or no. 11 and
the Original Glass.
Remove two control panel mounting screws. → Remove two
ground wire mounting screws. → Remove one flat cable and
unplug one connector.
Remove no. 5. → Remove one Right Inside Cover mounting
screw.
Remove no. 3. → Open the Front Door and remove six Front
Cover mounting screws.
Open the Front Door and remove one band mounting screw. →
Snap off one C-clip.
Slide out the 1st Tray. → Remove the fixing brackets on the right
and left.
Remove no. 3. → Remove no. 5. → Remove no. 14. → Remove
five Left Cover mounting screws.
Remove no. 3. → Remove no. 5. → Remove no. 14. → Remove
no. 8. → Remove two screws and two Upper Cover mounting
screws.
Remove no. 3. → Remove no. 5. → Remove no. 14. → Remove
no. 8. → Remove no. 9. → Remove no. 4. → Remove two Rear
Inside Cover mounting screws.
Remove two ADF Glass mounting screws.
Remove no. 14. → Remove three Left Hinge mounting screws.
Remove no. 14. → Remove three Right Hinge mounting screws.
Remove six Rear Cover mounting screws.
Remove no. 14. → Remove one Rear Right Cover mounting
screw.
Remove two Multiple Bypass Cover mounting screws.
Remove no. 14. → Remove no. 15. → Remove three Right Door
mounting screws.
Remove no. 3. → Remove no. 5. → Remove no. 14. → Remove
four Right Cover mounting screws.
D-8
Removal Procedure